when using, installation and debugging is necessary.
It is pointless to work on the un-debugging surface plates. If installation and debugging is carried out by unqualified specialists, it is possible that the surface plate is damaged, even worse, deformed and unusable. So before using, the Lineation surface plates should be adjusted and debugged by professional specialists, operating against regulations is not allowed.
After debugging, we need to clean the working surface, if there is not any problem then using. We need to prevent the excessive collision between workpiece and lineation surface plate in case of damages of surface plates working surface. The weight of workpiece should be lighter than load rating, if not it will be low down the working quality, damage the structure of surface plates, even wore, it will deform and be unusable.